Miscellaneous—Machine Adding Oil to the Roller NOTE: Rollers are serviced off of the machine. 1. Remove plug (B) from roller. 2. Rotate plug opening to 45° angle. T113532 —UN—17FEB98 3. Fill roller with oil until the oil starts to drip out. See Track Rollers, Front Idler and Carrier Roller Oil. (Section 3-1.) 4. Apply pipe sealant or TEFLON® tape to new plug. Install plug. B—Plug TEFLON is a registered trademark of Du Pont Co. CED,OUO1032,1041 -19-14JAN08-1/1 Do Not Service Control Valves and Cylinders Special tools and information are needed to service control valves and cylinders. If these parts need service, see your authorized dealer.
T82,BHMA,K -19-14JAN08-1/1 Adjusting Engine Speed Control Lever Tension (Earlier Machines) 1. Open the left rear service door. 2. Adjust lock nut (A) until a minimum of 31—40 N (7—9 lb) force is required to initiate movement in the forward direction using a spring scale placed just below the knob of the lever. T117999B —UN—24NOV98 A—Lock Nut T118767 —UN—11DEC98 CED,OUO1032,787 -19-02JUN03-1/1 4-1-19 070813 PN=135