John Deere 450H, 550H, 650H — Cooling System Checks

Miscellaneous—Operational Checkout Operational Checkout Use this procedure to check all systems and functions on the machine. It is designed so you can make a quick check of the operation of the machine while doing a walk-around inspection and performing specific checks from the operator's seat. A location will be required which is level and has adequate space to complete the checks. No tools or equipment are needed to perform the checkout. Complete the necessary visual checks (oil levels, oil condition, external leaks, loose hardware, linkage, wiring, etc.) prior to doing the checkout. The machine must be at operating temperature for many of the checks.

Should you experience a problem with your machine, you will find helpful diagnostic information in this checkout that will pinpoint the cause. This information may allow you to perfume a simple adjustment which will reduce the downtime of your machine. Use the table of contents to help find adjustment procedures. Start at the top of the left column and read completely down the column before performing check, follow this sequence from left to right. In the far right column, if no problem is found (OK), you will be instructed to go to next check. If a problem is indicated (NOT OK), you will be referred to either a section in this manual, or to your authorized dealer.

The information you provide after completing the operational checkout will allow you or your authorized dealer to pinpoint the specific test or repair work needed to restore the machine to design specifications. HG31779,00000D1 -19-03SEP02-1/57 Cooling System Checks HG31779,00000D1 -19-03SEP02-2/57 Radiator Cap, Coolant Level, Coolant Condition Checks CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. DO NOT remove radiator cap unless engine is cool. Then turn cap slowly to the stop. Release all pressure before you remove cap. Open radiator cap. LISTEN:

If radiator is warmer than air temperature, a "whoosh" must be heard when radiator cap is opened to first stop position. OK: Check complete. FEEL: The radiator cap must have a stop position and must be pushed down to turn to remove. NOT OK: If vacuum release valve is plugged or spring corroded, replace radiator cap. Inspect coolant level, coolant condition. NOT OK: If coolant is oily or foamy, see your authorized dealer. LOOK: The radiator cap must have a good seal and gasket. The seal must move freely and the spring must not be corroded. NOT OK: If rust in coolant, drain, flush and replace coolant, see Drain the Cooling System. (Section 4-1.) LOOK:

The coolant must not be oily, foamy, or rusty. NOT OK: If radiator is low and coolant tank has coolant in it, check for air leak on recovery hose. See your authorized dealer. Continued on next page HG31779,00000D1 -19-03SEP02-3/57 4-2-1 070813 PN=140