John Deere 450H, 550H, 650H — Transmission Checks

Miscellaneous—Operational Checkout Steering Checks Transmission speed control at minimum speed position or speed in grip (if equipped) at 1.0. Run engine at approximately 1200 rpm. FNR to forward. Move steer lever or speed in grip to right hand detent position. LOOK: The right hand track should stop and transmission pressure should remain in the green. Move steer lever to maximum right hand position. LOOK: The right hand track must counter-rotate and transmission pressure should remain in the green. OK: Check complete. Repeat check for left hand track. NOT OK: If track will not stop or will not counter-rotate. See your authorized dealer. NOTE:

Steering rate and modulation can be set to operator prefer- ence (Low, Med or High). NOT OK: If charge pressure is not in green. See your authorized dealer. StrR (Steer Rate) Setting the machine responsiveness to a change in steering lever movement for right and left steer. StrM (Steer Modulation) Setting the right and left modulation changes the amount of steering that occurs for a given amount of steering lever movement. HG31779,00000D1 -19-03SEP02-21/57 Decelerator Pedal Check Start engine. Park lock lever down. Depress decelerator pedal. Move engine speed control lever to fast idle. Transmission speed control at maximum speed or speed in grip (if equipped) to 3.0. FNR in forward.

Release decelerator pedal. LOOK: Machine must accelerate smoothly to maximum speed. OK: Check complete. NOTE: Decelerator response time can be set to operator preference. NOT OK: If engine speed increases and decelerator pedal moves up, see your authorized dealer. HG31779,00000D1 -19-03SEP02-22/57 FNR Check Engine speed at 1500 rpm. Transmission speed control at position 1 1/2 or speed in grip (if equipped) to 2.0. Make several shifts from neutral to forward, neutral to reverse and then forward to reverse. Specification Engine—Speed.................................................................................................1500 rpm LOOK:

Observe how both tracks start to increase in speed. Both tracks must start at the same time and machine should move forward or reverse in a straight line. OK: Check complete. NOTE: FNR shift rate can be set to operator preference. Low has a slower reaction time and high has a quicker reaction time. NOT OK: See your authorized dealer. HG31779,00000D1 -19-03SEP02-23/57 Multi-Function Relief Valve Check (Closed Loop System Relief Valve) Engine at fast idle. Transmission speed at 2 1/2 position or speed in grip (if equipped) to 2.5. Machine at operating temperature. Place machine under heavy load with blade. LOOK: Machine must push straight and tracks maintain same speed. OK: Check complete.

LISTEN: Engine must not cycle as heavy load is pushed. NOT OK: See your authorized dealer. Continued on next page HG31779,00000D1 -19-03SEP02-24/57 4-2-8 070813 PN=147