Operation—Operator's Station If engine coolant temperature indicator lights indicating that the temperature is excessively high, DO NOT stop engine. Reduce load and run engine at fast idle for several minutes. Stop engine and service machine. power train damage may occur. See your authorized dealer to correct low pressure. After the engine is started, the gauge needle must move above the point within a few seconds. If not, stop engine and see your authorized dealer. 15—Start Aid Button: Press and hold button when engine is cold and cranking to inject starting fluid into engine during cold weather start-up. 18—Under-Seat Heater ON/OFF Switch: Push upper half of switch to turn heater on.
Push lower half to turn heater off. 16—Front and Rear Work Lights Switch: Push upper half of switch to turn front and rear work lights on. Push lower half to turn lights off. 19—Key Switch: 17—Transmission Oil Pressure Gauge: IMPORTANT: If needle remains in red zone after warm-up or moves to red zone while operating, HG31779,00000AC -19-11JUL02-2/2 Transmission Controller Display Window When an active service code is received by the transmission control unit, the code will appear in the display window (A). See Transmission Controller Service Codes for explanation of service codes. (Section 4-3).
A—Transmission Controller Display Window T118638 —UN—24NOV98 Continued on next page CED,OUO1032,1171 -19-24APR99-1/6 2-1-5 070813 PN=31