Operation—Operating The Machine Starting Fluid (Cold Weather Start Aid)—If Equipped A coolant heater without starting fluid is sufficient for cold starting when temperature is down to (—13°F). The starting fluid option is required when ambient temperature is below 0°C (32°F) and the machine is not equipped with a coolant heater. TS281 —UN—15APR13 Using Starting Fluid CAUTION: Prevent possible injury from exploding container. Starting fluid is highly flammable. Keep container away from heat, sparks, and open flame. Contents are pressurized. Do not puncture or incinerate container. Remove container from machine if engine does not need starting fluid. IMPORTANT: Prevent damage to engine.
Use starting aid if necessary when temperatures are below 0°C (32°F) and only when engine is COLD. Do not use ether aid and coolant heater together. T118117 —UN—11DEC98 1. Turn key switch clockwise to “Start” position. IMPORTANT: Excess starting fluid could damage engine; push starting aid button only when engine is cold and cranking. Starting aid fluid is being injected into engine as long as you push and hold button. Earlier Machines 2. After one or two revolutions of engine crankshaft, push and hold starting aid button (A) for short intervals. Crank engine for 20 seconds maximum, then allow 2 minutes between cranking periods.
T157936B —UN—22JUL02 A—Start Aid Button Later Machines HG31779,00000BB -19-22JUL02-1/3 Replacing Start Aid Can 1. Turn container (B) counterclockwise to remove the start aid can. 2. Remove safety cap and spray button from new can. 3. Turn can in start aid base (C) to install. T117489 —UN—12NOV98 B—Container C—Base Continued on next page HG31779,00000BB -19-22JUL02-2/3 2-2-8 070813 PN=46