John Deere 450H, 550H, 650H — Operating in Mud or Snow

Maintenance—As Required NOTE: Grease gun with 52 200 kPa (552 bar) (8000 psi) minimum capacity is required. 2. Apply grease to grease fitting (B) using a 55,200 kPa (550 bar) (8000 psi) capacity grease gun. 3. After adding grease, move machine forward and reverse to allow track adjuster cylinder to fully adjust. 4. Check track sag again. Repeat procedure if necessary. 5. Install plug. Increase Track Sag: 1. Remove access plug. 2. Loosen fitting (C) (not grease fitting), one to two turns counterclockwise to release grease through vent hole (D). T118012B —UN—01DEC98 3. Tighten fitting. 4. Move machine forward and reverse to allow track adjuster cylinder to fully adjust. 5.

Check track sag again. Repeat procedure if necessary. Grease Fitting 6. Install plug. B—Grease Fitting C—Fitting D—Vent Hole T118013B —UN—11NOV98 Vent Hole CED,OUO1032,1028 -19-12JAN12-2/2 3-3-4 070813 PN=93