John Deere 450H, 550H, 650H — Check Hydraulic Oil Level

Maintenance—Every 10 Hours or Daily Check Engine Oil Level IMPORTANT: Do not run engine when oil level is below the ADD mark. The most accurate oil level reading is obtained when the engine is cold before starting the engine for the day's operation. T118421 —UN—12NOV98 1. Park machine on a level surface. 2. Engage the park lock lever in the locked position. 3. Make sure dipstick is fully seated. 4. Remove dipstick (A) to check oil level. 450H Shown BEFORE THE ENGINE IS STARTED: The engine is full when oil level is in the cross-hatch area (C). It is acceptable to run the engine when the oil level is above the ADD mark. AFTER THE ENGINE HAS BEEN RUN:

Allow the oil to drain into the oil pan for 10 minutes before checking the oil level. Ten minutes after shutdown the engine oil level must be above the ADD mark. RG5421 —UN—15DEC88 5. If necessary, remove the filler cap (B) to add oil. See Diesel Engine Oil. (Section 3-1.) 6. Check oil on dipstick again. A—Dipstick B—Filler Cap C—Dipstick Cross-Hatch Area 03T,60,K96 -19-24APR99-1/1 Drain Water Separator Sediment 1. Loosen drain valve (A). Drain liquid for several seconds or until water and sediment is removed. 2. Tighten drain valve. 3. Bleed fuel system. See Replace Primary Fuel Filter. (Section 3-7.) T118231C —UN—25NOV98 A—Drain Valve HG31779,00000CF -19-03SEP02-1/1 3-4-2 070813 PN=96