. ATTACHMENTS, OPTIONS TACHOGRAPH (TCO 15-6) METHOD OF USE 6 - 18 Before inserting items. (Operator Fill in the above it Handle the charts scratch them. new chart paper, always fill in the required code No., machine code No., date, etc.) ems with a steel pen. carefully with clean hands, and do not fold or 5. Push down press ing ring (4) holding the charts, turn counterclockwise, and pull o ut the pressing ring at the point where it contacts the stopper, then remove the charts. . ring (4), then set the charts under cutting knife (5). When doing this, align the time on the le when the starting time is 9 am) exactly with red point (6) on the instrument body. 6.
Insert new charts Remove pressing charts (for examp le when the starting time is 9 am) exactly with red point (6) on Precautions when re placing the charts When aligning the ch arts with the center of the chart support, do not force them into position or use your fin ger to make the hole in the center of the chart paper larger. If the size of the hole change s, it may cause an error i n the recording. pletely before inserting the new charts. Stop the engine com Use Komatsu genuin e charts (P/N: YZ762929-980) for 90 km/h (55.9 MPH) 7 days. 7. Close the cover. Lift up the cover t o close it, then turn the instrument open/lock key 90° clockwis