. ATTACHMENTS, OPTIONS HANDLING OIL FILTER CAUTION WHEN CHECKING OIL, FILTER REPLACEMENT INTERVAL 3. When the displayed time lights up, it shows the time remaining to replacement. If the time display flashes, it shows the time that has elapsed since replacement was due. OPERATING SWITCH WHEN REPLACING OIL, FILTERS 1. After replacing the oil and filters, use the procedure for checking the replacement interval to reset the display for the item that has been replaced. 2. Keep the replacement switch pressed for at least 2 seconds. The display will change to the time until the next replacement, and the switch operation is complete. 3. After completing the switch operation, start the engine.
If the wrong replacement item is selected when operating the switch, press the cancel switch to return to the condition before the switch was operated, then operate the switch again. Always stop the engine before operating the switch. 6 - 50 1. All lamps light up when the starting switch is turned ON, and after 3 seconds, the display shows t he engine oil replacement i nterval. 2. When checkin g th e oil replacement i nterval , press the left replacement interval check switch; when checking the filter replacement interval, press the right r eplacement interval check switch. The display is give n in the order shown in the t able The default se t intervals ar e as f ollows.
Item Replacement interval Engine oil 500 Transmission oil 1000 Hydraulic oil 2000 Final drive case oil 2000 Differential case oil 2000 Engine oil filter 500 Fuel filter 500 Corrosion resistor 1000 Transmission oil filter 500 Hydraulic filter 1000