. SAFETY PRECAUTIONS FOR MAINTENANCE 2 - 31 REMOVING BATTERY TERMINA When repairing the electrical system or when carrying out electric al welding, r emove the n egative (- ) termin al of the battery to prevent the flow of PRECAUTIONS WITH HIGH-PRE SSURE OIL ays under internal pressure. When inspecting or replacing piping or hoses, always The hydraulic system is alw inspecting or replacing hoses, always check that the pressure in the hydraulic circuit has been released . If the c ircuit is still und er pressure, it will lead to serious personal injury, so al ways do as follows. For details of the method o f releasing the pressure: see the sec tion on " INSPECTION AND ADJUSTME NT".
Do not carry out any inspectio n or replacement operation before t he pressure has been c ompletely remove d. If there is any leakage from the piping or hoses, the surrounding area wi ll be wet, so che ck for cracks in th e piping and hoses and for swelling When carry out inspection , wear safety glasses and leather gl There is a hazard that high -pressure oil leaking from small hole may penetrate your skin or cause blindness if it contacts you eyes directly. If you are hit by a jet of high-pressureoil and suffe injury to your skin or eyes, wash the place with clean water, an consult a doctor immediately for medical attention.
may penetrate your skin o r cause blindness if it contacts you eyes directly. If you are hit by a jet of high-pressureoil and suffe injury to your skin or eyes, wash the place with clean water, an consult a doctor immediat PRECAUTIONS FOR HIGH-PRES When the engine is running, high-pressure is generated in the en gine fuel piping. When carrying out i nspe ction or maintenance of the fuel piping system, stop the engine and wait fo r at least 30 seconds to a llow the internal p ressure to go down before starting th HANDLING HIGH-PRESSURE HO SES, PIPING If oil or fuel leaks from high -pressure hoses, it may cause fire or defective operation, w hich may lead to serious injury.
If any loose bolts ar e found, stop work and tighten to the specified torque. If any d amaged hoses ar e found, stop operations immediate ly and contact your Komatsu distrib Replace the hose if any of th Damaged or leaking hydr Frayed or cut covering or Covering swollen in place Twisted or crushed mova Foreign material embedde