. OPERATION EXPLANATION OF COMPONENTS FRONT BRAKE CUT-OFF SWITCH WARNING and travel slowly at a safe speed. icy road, on snow, or on other slippery road 3 - 27 When traveling on icy roa ds, on snow, or on other slippery roa d surfaces, set the front bra ke cut-off switch to t he ON position If the front brake cut-off hen traveling on that the steering will be impossible t o control. This switch (5) switches t he braking method according to t he road surface conditions. the lamp lights up, the front brake cut the brakes are not applied to the front again, the lamp goes out and the front eled. ): If the switch is pressed, function is actuated, and wheels.
If the switch is pressed If brake cut function is canc OFF position (Light is off. When the brake pedal is d epressed, the brakes are applie d to both the front and rear wheels . : s depressed, the front brakes are not pplied only to the rear wheels. ON position (Light is on.) When the brake pedal i applied. The brakes are a HAZARD LAMP SWITCH e left- and right-hand turn signal lamps. This switch (6) flashes th e left- and right-hand turn signal lamps. When the switch is turne d on, the turn signal pilot lamp fla shes at the same time. If the sta lamp does not flash.
rting switch is OFF, the turn signal pilot NIGHT LIGHTING DIMMER S WITCH This switch (7) is used to adjust the brightness of the monit or panel lighting and pilot lamps. Turn to the right to make the lighting brighter and turn it to the left to make the lighting dimmer.