. OPERATION EXPLANATION OF COMPONENTS 3 - 28 POWER MODE SELECTOR SWITCH The power mode switch (8) can be switched to allow the machine to travel economically in a way suited to the nce, it lights up; if depressed once again, the light goes off. operations) al operating conditions. lat areas) The power m ravel operating co nditions. If depressed o nce, it lights up; if de pressed once again, the light goes off OFF position : High power (general This is used for gener al operating conditio ON position: economy (traveling in f This position is used w hen the emphasis is on reducing fue l consumption, such a s when traveling on flat ground where maxi mum output is not n eeded.
(HD325, HD4 (HD325 only the machine of 4WD s AISS LOW SWI TCH witch (9), it is possible to switch the AISS freely O and LOW. Use each position as follows. Using this s between AUT O and LOW. Use eac h position as follows If the switch i s depressed, it lights u ht goes off. p, and if it is depressed once sition l operation d position sed once again, the lig OFF position (Light is off): AUTO po At norma ON position (Light is on): Low spee When the needed li garage delicate start and op eration is ke putting the machine into mac nto If the switch i s at AUTO position: 1. When sto speed. W 2. Detecting and the w 1.
When sto pping the machine, by setting either parking brake or retarder brake at ON position , idling is set at low hen starting, by setting the parking brake a t OFF position, idling is set at high spe ed. 2. Detecting the water temperatur e, idle is set at high s peed automatically under the low tem perature condition, arm-up time is shorten ed.