. OPERATION EXPLANATION OF COMPONENTS SECONDARY BRAKE LEVER This lever (12) is used to actuate the secondary brake. APPLIED: Secondary brake actuated TRAVEL: Secondary brake released If the pressure inside the air tank drops below 0.32 MPa (3.2 kg/cm 3 - 29 4WD SWITCH f 4WD specifications) essed, it lights up; if it is pressed once ve) travel travel (HD325 only the machine o When the switch (10) is pr again, the light goes off. OFF: 2WD (Rear wheel dri ON: 4WD (All wheel drive) Change from 4WD travel to 2WD travel and back at a travel s peed below 10 km/h (6.2 MPH). EMERGENCY STEERING SWIT CH This switch (11) is used to actuate the emergency steering p ump.
When the switch is presse d, the emergency pump is actuated to the steering. make it possible to operate When the switch is ON, the pilot lamp (red) inside the switch lights up. The emergency steering p ump can be used for a maximum of 90 seconds. When the emergency steer ing is being used, keep the travel s peed to a maximum of 5 km/h (3 .1 MPH). When the emergency steer ing is actuated, it is possible to us e the dump lever to raise the du mp body.
Automatic emergency stee ring will be actuated automaticall y in the following When hydraulic pump fo When engine has stopp When the automatic emerg ency steering is actuated, stop th e machine promptly and perform insp If the key switch is turned ON when the machine is stop ped and the parking brake switch is OFF, the auto emergency steering is actu ated after 1 second, so turn the p arking brak e switch to the ON (PARKI NG) position. 2, 45.1 PSI), the secon dary brake and parking brake are applied because of a failure in the air automatically applied. If the secondary brake is system, the central warnin sounds.
For details of releasing the g lamp flashes and the alarm buzzer brake when the secondary brake has uzzer been applied because of a f ailure in the air system, see "RELEASE METHOD WHEN PARKIN G BRAKE AND SECONDARY BR AKE HAVE BEEN ACTUATED IN EMERGENCY (PAGE 3-119)" .