. OPERATION EXPLANATION OF COMPONENTS GEAR SHIFT LEVER The gear range can be selected with this lever (3) to match the travel conditions. R position: This is used when traveling in reverse. This position uses the torque converter drive. FLOAT position. Set the dump lever to the The speed ranges for each position are as follows. Position Speed range Max. speed [km/h (MPH)] 5 1st torque converter - 5th direct 39.8 (24.7) 4 1st torque converter - 4th direct 29.6 (18.4) 3 1st torque converter - 3rd direct 21.8 (13.5) L 1st torque converter - 2nd direct 16.3 (10.1) When operating the shift lever, be sure to set it in position securely.
If the lever is not placed in position properly, the shift position display on the panel may go out and the transmission warning monitor lamp may light up. 3 - 33 ACCELERATOR PEDAL djust the engine speed. This pedal (2) is used to a It can be operated freely b etween the engine low idle position a nd the full throttle position. D position: vel. is position, the transmission is shifted orque converter drive to 7th speed to the machine. , the shift lever is fixed at 2nd. Always n traveling. is position is 70 km/h (43.5 MPH).
This is used for normal tra If the lever is placed in th automatically from 2nd t match the travel speed of If the dump body is raised lower the dump body whe The maximum speed in th is position is 70 km/h (43.5 MPH). The machine cannot trav el in reverse if the dump lever i s not at the FLOAT position before mo ving the shift lever to the R position. 5 - L position: These positions are used in places where it is difficult to t ravel at high speed, or when trav eling on soft ground, or when starting the machine off on a slope when it is loaded . They are a lso used when goin g downhill if it is needed to use the braking force of the engine. , it is impossible to shift up from 1st.
Always lower the dump body when traveling. If the dump body is raised , it is impossible to shift up from 1st. Always lower the dump bod