. OPERATION EXPLANATION OF COMPONENTS The shift lever must not be returned to the N (neutral) position while traveling. DUMP LEVER LOCK WARNING When raising the dump body to inspect the machine, always place the dump lever at the HOLD position, apply the lock, and then use the body pivot pins. This device (4) is used to lock the dump lever. DUMP LEVER CAUTION To prevent damage to the dump body through vibration from the road surface, always lower the dump body and set at FLOAT position before traveling. This lever (5) is used to operate the dump body. 1: RAISE 2: HOLD: The dump body stops and is held in position. 3: FLOAT: The dump body moves freely under external force. 4:
LOWER For details, see "DUMP OPERATIONS (PAGE 3-98)". 3 - 34 Before shifting between forward a nd reverse, stop the machine completely and then run the engine at low When starting the engine, if the ge ar shift lever is not at the N position, the engine will no When the starting switch is turne d to the ON position, if the shift lever is not at the transmission shift lever position pil ot lamp and the central warning lamp will flash and the alarm buzzer will sound. If shift lever is not at N (neutral) po sition when the parking brake is applied, the central w arning lamp will fl ash and the alarm buzzer will sound.
If the shift lever is set to any positi on other than N (neutral) when the dump lever is at a p osition other than FLOAT or the body is still raised, the centr al warning lamp will light up and the alarm buzzer will sound. Release the accelerator pedal and run the engine at low idle when moving the shift lever from the N positio n to the forward or reverse position. When moving the gear shift lever f rom the N (neutral) position to the R (reverse) position or from the D pos itions to position 5 (or other lower position) , press the lock button on the gear shift lever before m oving it.