Operator Cab And Controls - Section 32 8/11 OM3232 Page 32-18 No Propel Indicator light (4, Figure 32-9) will illuminate to indicate that a fault has occurred which has eliminated the propulsion capability. If this condition occurs, the operator should safely stop the truck, move the directional control lever to PARK, shut down the engine, and notify maintenance personnel immediately. Wheel Brake Lock Applied Indicator light (8, Figure 32-8) will illuminate when the wheel brake lock is on. The wheel brake lock should only be used when the truck is completely stopped and in loading position.
Traction Control Indicator light (9, Figure 32-8) will illuminate when the traction control switch is in the OFF position. This feature should always be used when conditions are wet or slippery. Engine Warming Up Indicator light (5, Figure 32-9) not used this application. Engine Delay Repair Monitor When the key switch has been turned OFF, and certain conditions have been met, this indicator light (6, Figure 32-9) will illuminate to indicate that the shutdown timing sequence has started. The engine could oper- ate for up to three minutes. Indicator light (10, Figure 32-8) will illuminate if a “repair” fault is detected, which must be corrected after the operator’s shift is done.
If the directional control lever is moved out of PARK, the engine will stop immediately. Snapshot Indicator light (11, Figure 32-8) indicates that the KOMTRAX Plus system is in the process of recording a “snapshot” of certain vehicle conditions. If the key switch is turned back ON, the engine stop sequence will be terminated, and the engine will remain running. Grid Drier Indicator light (7, Figure 32-9) indicates that the grid drier feature is in operation. This feature is used to dry the retarding grids when starting the truck after it has been washed or parked in rainy conditions.