Komatsu — Operation

Operator Cab And Controls - Section 32 8/11 OM3232 Page 32-24 KOMTRAX PLUS Operation This system uses the KOMTRAX Plus controller (2, Figure 32-12) to gather data about the operation of the truck from sensors and other controllers installed on the truck. The data stored in the KOMTRAX Plus controller is downloaded by computer using KOMTRAX diagnostic port (6, Figure 32-4) or transmitted directly by communications satellite utilizing Orbcomm controller (1, Figure 32-12), if equipped. This data is then compiled at the Komatsu computer server.

Based on this information, the servicing Komatsu distributor will suggest improvements and provide information aimed at reducing machine repair costs and downtime. The KOMTRAX Plus system uses wireless com- ponents that transmit via radio waves. It is neces- sary to conform to local laws when using this system. Proper operation of the system is dependent on good reception. Operating in tunnels, mountain ranges and covered areas may prevent communi- cation of the system. Contact your Komatsu distributor before selling or exporting a truck equipped with KOMTRAX Plus. It may be necessary to remove the system before transfer of ownership. NOTE:

A contract is necessary before KOMTRAX Plus can be used. Contact your Komatsu distributor for more information. Contact your Komatsu distributor before install- ing equipment that may interfere with the KOM- TRAX Plus system. Komatsu is not responsible for any failures that result from neglecting KOMTRAX Plus system precautions and instructions. DO NOT disassemble, repair, or modify the KOM- TRAX Plus system without proper authorization. Changes to the system may cause machine fail- ures and fire. DO NOT touch the KOMTRAX Plus system com- ponents during machine operation. ORBCOMM is a two-way radio communication device.

Wireless signals from the system can interfere with other wireless signals in the area. This interference can cause a malfunction in a blast zone resulting in an unintended detonation. Know the locations of blast zones in the area and keep a safe distance to avoid unintentional blasts. If the machine is operating within a dis- tance of 12m (40 ft) of a blast zone, disconnect the ORBCOMM harness. Failure to do so could result in serious injury or death. DO NOT pull on KOMTRAX Plus system wiring harnesses, connectors, or sensors. This may cause short circuits or open circuits and lead to machine failure or fire. DO NOT allow water, dirt, or oil onto system com- ponents.

The ORBCOMM satellite requires the installation of a pole and antenna, adding to the overall height of the machine. The height increase is 410 mm (16.2 in.). With the guard installed, the overall height increases another 260 mm (10.2 in.). Use caution when operating in areas with height restrictions. This warning does not supersede requirements or regulations of the area or country where this machine is in operation. The following specifica- tions are provided to ensure compliance with all of the applicable requirements or regulations: Transmit power: 5-10 Watts Operating Frequency Range:

148 - 150 MHz Anyone with a pacemaker must remain a mini- mum of 22 cm (9 in.) from the communications antenna. Radio waves from the antenna can interfere with pacemaker operation.