Komatsu — Operation

OM3232 8/11 Operator Cab And Controls - Section 32 Page 32-25 NOTE: The ORBCOMM modem installed from the factory on all new trucks may not be approved for use in certain countries of the world. Local regulation may prohibit the use of the ORBCOMM modem/ satellite communicator. Depending on local regulation, you may need to either remove the modem or disconnect it and remove the antenna. During normal truck operation, the red LED digits on the KOMTRAX Plus controller will count from 1-99 continuously. When the key switch is turned to OFF, the controller will remain on while it finishes processing internal data and saves the recent data into permanent memory.

When the data has been safely stored, the two digit LED display will turn off. This process could take up to three minutes to complete. Check with KAC service for assistance and preferred action in your area. The following is a list of "at risk" countries: China, Russia, Serbia, Tanzania, Senegal, Zambia, Botswana and Namibia. If 24V power is disconnected (using the battery disconnect switches) from the KOMTRAX Plus controller before it has completed its shutdown procedure, the controller will lose all data gathered since the key switch was last turned to ON. Do not disconnect battery power until the controller has completed the shutdown procedure and has turned the LED digits off.

When data store button (1, Figure 32-11) on the rear of the center console is pressed, it will store a “snapshot” of the SIBAS drive system. It will also trigger KOMTRAX Plus to store a snapshot of the truck operating system. A “snapshot in progress” message will be displayed on the speedometer/ digital display while KOMTRAX Plus system is recording the snapshot. KOMTRAX is turned on by the truck key switch. Immediately after receiving 24V power from the key switch, the KOMTRAX Plus controller begins the power-up initialization sequence.

This sequence takes about three seconds, during which time red LED digits (3, Figure 32-12) near the top of the controller will display a circular sequence of flashing LED segments. FIGURE 32-12. KOMTRAX PLUS COMPONENT LOCATION (R.H. WALL OF AUXILIARY CONTROL CABINET) 1. Orbcomm Controller 2. KOMTRAX Plus Controller 3. Red LED Digits FIGURE 32-11. REAR OF CENTER CONSOLE 1. Data Store Button