Komatsu — Adding Oil

OM4057 9/11 Lubrication and Service - Section 40 Page 40-1 LUBRICATION AND SERVICE GENERAL HYDRAULIC TANK SERVICE Recommended preventive maintenance will contribute to the long life and dependability of the truck and its components. The use of proper lubricants and the performance of checks and adjustments at the recommended intervals is most important. There are two sight gauges on the side of the hydraulic tank. With the engine stopped, key switch OFF, hydraulic system bled down and body down, oil should be visible in the top sight gauge. If hydraulic oil is not visible in the top sight gauge, follow Adding Oil instructions below.

Lubrication requirements are referenced to the lube key found in the Lubrication Chart (page 2-5). For detailed service requirements for specific components, refer to the shop manual section for that component. Adding Oil Keep the system open to the atmosphere only as long as absolutely necessary to lessen the chances of system contamination. Refer to the manufacturer's service manual when servicing any components of the propulsion system. Service the tank with clean Type C-4 hydraulic oil only. All oil being put into the hydraulic tank must be filtered through filters rated at three microns. Refer to engine manufacturer's service manual when servicing the engine or any of its components. 1.

Ensure that the engine is stopped, key switch is OFF, hydraulic accumulators depressurized, and body is down. The service intervals presented here are in hours of operation. These intervals are recommended in place of an oil analysis program which may determine different intervals. However, if the truck is being operated under extreme conditions, some or all of the intervals may need to be shortened and the service should be performed more frequently. 2. Remove fill cap (2, Figure 40-1) and add hydraulic oil until the oil level is visible in the center of the top sight gauge. 3. Install the fill cap. 4. Start the engine. Raise and lower the dump body three times.

The truck is equipped with an automatic lubrication system. The initial setup for this system provides for nominal amounts of lubricant to be delivered to each serviced point. The lubrication injectors can be adjusted to vary the amount of lubricant delivered. In addition, the timer for lubrication intervals is normally adjustable. For adjustments to these devices, refer to Section 42, Automatic Lubrication System. 5. Check the hydraulic oil level again with the engine stopped, key switch OFF, hydraulic accumulators depressurized, and body down. 6. Repeat Steps 1 - 5 until the oil level is main- tained in the center of the top sight gauge. 860E-1K SERVICE CAPACITIES FIGURE 40-1.

HYDRAULIC TANK SERVICE 1. Sight Gauges 2. Fill Cap Component/System Liters U.S. Gallons Crankcase Komatsu SSDA16V160 Engine 280 74 Cooling System Komatsu SSDA16V160 Engine 473 125 Hydraulic System Refer to “Hydraulic Tank Service” 1325 350 Wheel Motors (each side) 121 32 Fuel Tank (Diesel fuel only) 4542 1200 Inverter Cabinet Cooling System 25 6.5