Lubrication and Service - Section 40 9/11 OM4057 Page 40-2 COOLING SYSTEM SERVICE Coolant Specifications For ambient temperatures of -32° C (-25° F) and above, use a standard 50/50 anti-freeze-to-water mixture. Check the coolant level sight gauge. If coolant cannot be seen in the sight gauge, add coolant to the system before truck operation. Refer to the procedure below for the proper filling procedure. For arctic climates with ambient temperatures between -32° C (-25° F) and -54° C (-65° F), use a 60/40 anti-freeze-to-water mixture. Radiator Filling Procedure NOTE: Do not use propylene glycol coolant in arctic climates. Only use ethylene glycol coolants.
The cooling system is pressurized due to thermal expansion of coolant. Do not remove the radiator cap while the engine and coolant are hot. Severe burns may result. Unacceptable Practices Use of high-silicate anti-freeze. Under concentration or over concentration of Extended Service Additive (SCA). NOTE: If coolant is added using the Wiggins quick fill system, the radiator cap must be removed before adding coolant. Use of anti-freezes/coolants that are not fully formulated for extended service intervals. NOTE: Engine coolant must always be visible in the sight gauge before truck operation. Use of sealing additives (stop-leak) in the cooling system. 1.
With the engine and coolant at ambient temperature, remove the radiator cap (2, Figure 40-2). Use of soluble oils in the cooling system. Use of poor-quality water. See the engine manufacturer’s specifications for water quality requirements. 2. Fill the radiator with the proper coolant mixture until coolant is visible in the sight gauge. Use of anti-freeze, Extended Service Additive (SCA) or coolant filter(s) that do not meet the engine manufacturer’s specifications. 3. Install the radiator cap. 4. Run the engine for five minutes, then check the coolant level. Use of Treated Water coolant. 5. If coolant is not visible in the sight gauge, repeat Steps 1 - 4.
Any excess coolant will be discharged through the vent hose after the engine reaches normal operating temperature.. Use of coolants with less than 40 percent antifreeze. FIGURE 40-2. COOLING SYSTEM SERVICE 1. Sight Gauge 2. Radiator Cap