Komatsu — 10 HOUR (DAILY) INSPECTIONS

Lubrication and Service - Section 40 9/11 OM4057 Page 40-6 10 HOUR (DAILY) INSPECTIONS Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS MACHINE - Inspect the entire machine for leaks, worn parts and damage. Repair as necessary. TURBOCHARGERS - Check for leaks, vibration and unusual noise. RADIATOR - Check the coolant level, it must always be visible in the sight gauge. Refer to Cooling System Service for coolant specificaitons and filling procedure. Refer to the engine service manual for the proper coolant additives. ENGINE a.

Check the oil level. To obtain an accurate measurement, remove the dipstick and wipe it off. Then reinsert the dipstick and remove it again to check the oil level. Refer to the engine manual for oil recommendations. (Lube Key “A”). b. Check the oil level in the reserve tank. The oil level must be visible in the lower sight gauge. If it is not, add oil to the reserve tank using the reserve oil tank filling procedure. Also, with the engine running, check the operation of the LED monitor light. Refer to “Reserve Engine Oil System” in Section 30, Operating Instructions. c. Inspect exhaust piping for integrity. d. Check for abnormal noises and fluid leaks. e.

Eliminator Filter - Check operating indicator. HYDRAULIC TANK - Check the oil level in the tank. Oil should be visible in the top sight glass. Add oil if necessary. DO NOT overfill. Refer to Hydraulic Tank Service - Adding Oil - Lube Key “B”. WHEELS AND TIRES a. Inspect the tires for wear and proper inflation. b. Check for embedded debris in tread and remove. c. Check for damaged, loose or missing wheel mounting nuts and studs. Replace damaged or missing hardware and tighten to standard torque before truck operation.