Komatsu — 10 HOUR (DAILY) INSPECTIONS

OM4057 9/11 Lubrication and Service - Section 40 Page 40-7 10 HOUR (DAILY) INSPECTIONS (Cont.) 7. 8. 9. FIGURE 40-5. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS COOLING AIR DUCTWORK - Inspect the ductwork from the blower to the rear axle. Ensure that the ductwork is secure, undamaged and unrestricted. AIR CLEANERS - Check the air cleaner vacuum gauges in the operator cab, Figure 40-5. The air cleaner(s) must be serviced if the gauge(s) shows the following maximum restriction: Komatsu SDA16V160 or SSDA16V160 Engines: . . . .

. . . . . . . . . . . 625 mm (25 in.) of water vacuum. Refer to the shop manual for servicing instructions for the air cleaner elements. NOTE: After air filter service, push the reset button on face of gauge to allow the gauge to return to zero. DRIVE SYSTEM COOLANT - Check the sight gauges inside the drive system control cabinet. The upper sight gauge should be 1/2 full. If necessary, add coolant. Use Antifrogen only. WIPER & WASHER - Inspect the wiper blades for wear or damage. Replace if necessary. Check the windshield washer fluid level. If below 1/2 full, add windshield washer fluid.