Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

Lubrication and Service - Section 40 9/11 OM4057 Page 40-12 250 HOUR LUBRICATION AND MAINTENANCE (Cont.) FIGURE 40-9. 1. Filter Cover 2. Cab Filter 10. 11. 12. 13. 14. 15. 16. 17. 18. REAR AXLE HOUSING - Check the rear axle housing for oil leaks by removing the two drain plugs on the bottom of the axle housing. If oil is present, the cause of the leak must be found and corrected before operating the truck. FRONT WHEEL HUB - Remove the magnetic plugs from the front wheel hub covers and check for debris. Clean the plugs and perform any necessary repairs. MOTORIZED WHEELS a. Check for the correct oil level. There are eight oil level plugs.

Rotate the wheel so one plug is at the 6 o’clock position. The oil level should be even with the bottom of the plug opening. (Lube Key C) b. Inspect the magnetic plugs for ferrous materials. Service the wheel motor as necessary. WHEEL MOTOR OIL SAMPLING - Take an oil sample of the wheel motor oil. Refer to the shop manual for oil sampling instructions. BATTERIES - Check the electrolyte level and add water if necessary. DUMP BODY PADS - Check the pads, shims and mounting hardware for wear and proper tightening. BODY-UP AND HOIST LIMIT SWITCHES - Check the operation of the switches. Clean any dirt from the sensing areas and inspect the wiring for damage.

CAB RECIRCULATION AIR FILTER - Under normal operating conditions, clean every 250 hours. In extremely dusty conditions, service as frequently as required. Clean the filter element with mild soap and water. Rinse completely clean and allow to air dry before use. CAB AIR FILTER - Under normal operating conditions, clean every 250 hours. In extremely dusty conditions, service as frequently as required. Clean the filter element with mild soap and water. Rinse completely clean and air dry with a maximum of 275 kPa (40 psi). Reinstall the filter. Refer to Figure 40-9.