OM4057 9/11 Lubrication and Service - Section 40 Page 40-11 250 HOUR LUBRICATION AND MAINTENANCE (Cont.) 6. 7. 8. 9. FIGURE 40-8. FIGURE 40-7. TASK COMMENTS CHECKED INITIALS COOLING SYSTEM a. COOLANT MIXTURE - Check for proper coolant mixture. Add coolant as required. b. COOLANT FILTERS - Change coolant filters. c. COOLING SYSTEM HOSES - Check cooling system hoses for damage and signs of deterioration. Refer to the engine maintenance manual for coolant filter replacement instructions and proper coolant mixture instructions. STEERING LINKAGE a. Check the torque on the steering pin retaining nuts (1, Figure 40-8). Tighten to 712 N•m (525 ft lbs). b.
Check the torque on the tie rod retaining nuts (2). Tighten to 420 N•m (310 ft lbs). HYDRAULIC PUMP DRIVESHAFT & U-JOINTS - Add one or two applications of grease to each grease fitting. Ensure that each bearing of the cross and bearing assembly is receiving grease. Replace bearings if any wear is detected. (Lube Key D) REAR WHEEL MOUNTING - Use a flashlight and a mirror on a long rod to inspect all inner and outer wheel mounting nuts and studs. Check for loose, damaged or missing hardware.