Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

Lubrication and Service - Section 40 9/11 OM4057 Page 40-10 All 10 Hour (Daily) Inspections should also be performed at this time. 250 HOUR LUBRICATION AND MAINTENANCE CHECKS NOTE: “Lube Key” references are to the Lubrication Chart on page 40-5. *1. 2. 3. 4. 5. * This is required only after the initial 250 hours of operation , such as the commissioning of a new truck or after installing a new or rebuilt component. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS HYDRAULIC SYSTEM FILTERS - Replace the filter elements.

Check the oil level. Add oil as necessary. (Lube Key “B”) ENGINE - Refer to the engine manufacturer’s Opera- tion & Maintenance manual for complete specifica- tions regarding engine lube oil specifications. NOTE: If the engine is equipped with the *Centinel™ oil system and/or the Eliminator™ filter system, engine oil and filter change intervals are extended beyond 250 hours. Take an engine oil sample for analysis. Refer to engine Operation & Maintenance manual for specific oil and filter change intervals. * The Centinel™ system is a duty-cycle-dependent lubrication management system whereby oil is blended with the fuel and burned and an extension of oil change intervals can occur. a.

Change engine oil. (Lube Key A) b. If equipped, replace the engine oil filters. Follow the instructions of the filter manufacturer, which are normally printed on the outside of the filter. Do not use a wrench or strap to tighten filter elements. c. Check the torque on the cooling fan (1, Figure 40-7) mounting cap screws. Tighten cap screws (2) to 237 N·m (175 ft lb). d. Check the tension and condition of each accessory drive belt. Refer to the engine operation and maintenance manual for specific adjustment instructions. FUEL FILTERS - Change the Stage 1 and Stage 2 fuel filters. Refer to engine Operation & Maintenance manual for specific filter replacement instructions.

FUEL TANK - Drain water and sediment from the fuel tank. Refer to the shop manual for cleaning instructions. AIR INTAKE PIPING - Check all mounting hardware, joints and connections. Ensure that there are no air leaks and all hardware is properly tightened.