Komatsu — 6,000 HOUR MAINTENANCE CHECKS

Lubrication and Service - Section 40 9/11 OM4057 Page 40-18 5,000 HOUR MAINTENANCE CHECKS All 10 Hour (Daily) Inspections, 250 Hour Lubrication and Maintenance Checks, 500 Hour Lubrication and Maintenance Checks, and 1000 Hour Lubrication and Maintenance Checks should also be performed at this time. NOTE: “Lube Key” references are to the Lubrication Chart on page 40-5. 1. 6,000 HOUR MAINTENANCE CHECKS All 10 Hour (Daily) Inspections, 250 Hour Lubrication and Maintenance Checks, 500 Hour Lubrication and Maintenance Checks, 1000 Hour Lubrication and Maintenance Checks and 2000 Hour Lubrication and Maintenance Checks should also be performed at this time. NOTE:

“Lube Key” references are to the Lubrication Chart on page 40-5. 1. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS AIR CLEANERS - Clean the Donaclone tubes in the precleaner section of the air filter. Use low pressure cold water or low pressure air to clean the tubes. Refer to the shop manual for more specific cleaning instructions.

Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS MOTORIZED WHEELS a. Inside the rear axle housing, use the four grease fittings to grease the four wheel bearings. Each bearing requires 360 g (12.7 oz) of grease. (Lube Key E) b. Inspect each motor’s connections and check for external damage. c. Clean the drainage holes.