OM4057 9/11 Lubrication and Service - Section 40 Page 40-17 2,000 HOUR MAINTENANCE CHECKS All 10 Hour (Daily) Inspections, 250 Hour Lubrication and Maintenance Checks, 500 Hour Lubrication and Maintenance Checks, and 1000 Hour Lubrication and Maintenance Checks should also be performed at this time. NOTE: “Lube Key” references are to the Lubrication Chart on page 40-5. 1. 2. 3. 3,000 HOUR MAINTENANCE CHECKS All 10 Hour (Daily) Inspections, 250 Hour Lubrication and Maintenance Checks, 500 Hour Lubrication and Maintenance Checks, and 1000 Hour Lubrication and Maintenance Checks should also be performed at this time. NOTE: “Lube Key” references are to the Lubrication Chart on page 40-5. 1.
Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS MOTORIZED WHEELS - Drain and refill the wheel motor final drive with new oil. (Lube key C). IGBT CONTROL BOX - Inspect contactor K103, K105, and K109 for excessive wear, replace as necessary. GRID BLOWER SHAFT COUPLING - On the coupling, add one or two applications of grease.
(Lube Key G) Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS MAIN ALTERNATOR a. Add 80 g (2 oz) of grease per bearing. Do not over grease. (Lube Key E) b. Clean condensation water drain holes at the underside of the alternator.