Komatsu — Filter Assembly

OM4212 10/10 Automatic Lubrication System - Section 42 Page 42-5 GENERAL INSTRUCTIONS Required Lubricant Grease requirements will depend on ambient temperatures encountered during truck operation: Above 32°C (90°F) - Use NLGI No. 2 multipurpose grease (MPG). -32° to 32°C (-25° to 90°F) - Use NLGI No. 1 multipurpose grease (MPG). Below -32°C (-25°F) - Refer to local supplier for extreme cold weather lubricant requirements. System Priming The system must be full of grease and free of air pockets to function properly. After maintenance, if the primary or secondary lubrication lines were replaced, it will be necessary to prime the system to eject all entrapped air. 1.

Fill the lube reservoir with lubricant, if necessary. 2. To purge air from the main supply line, remove the main supply line at the grease canister. Connect an external grease supply to the line. 3. Remove the plugs from each injector group in sequence (right front, left front, and rear axle). 4. Using the external grease source, pump until grease appears at the group of injectors, then install the pipe plug. Repeat for the remaining injector groups. 5. Remove the caps from each injector and connect an external grease supply to the fitting on the injector. Pump until grease appears at the far end of the individual grease hose or the joint that is being greased. FIGURE 42-4.

FILTER ASSEMBLY 1. Housing 2. Bypass Indicator 3. O-Ring 4. Backup Ring 5. Element 6. Spring 7. Bowl 8. O-Ring 9. Plug Filter Assembly Filter element (5, Figure 42-4) must be replaced if bypass indicator (2) shows excessive element restriction.