OM5049 5/11 Components & Specifications - Section 5 Page 50-1 COMPONENTS & SPECIFICATIONS MAJOR COMPONENT DESCRIPTIONS Truck And Engine Operator's Cab The 860E Dump Truck is an off-highway, rear dump truck with AC Electric Drive. The gross vehicle weight is 454 363 kg (1,001,700 lbs). The engine is a Komatsu SSDA16V160 rated @ 2700 HP (2014 kW). The operator cab has been engineered for operator comfort and to allow for efficient and safe operation of the truck. The cab is rubber-mounted to reduce noise and vibration, provides wide visibility with an integral 4- post ROPS/FOPS structure, and has an advanced analog operator environment.
It includes a tinted safety-glass windshield and power-operated side windows, a deluxe interior with a fully adjustable seat with lumbar support, a fully adjustable/tilt steering wheel, controls mounted within easy reach of the operator, and an digital/analog instrument panel which provides the operator with all instruments and gauges which are necessary to control and/or monitor the truck's operating systems. Main Alternator The diesel engine drives an in-line alternator at engine speed. The alternator produces AC current which is rectified to DC within the main control cabinet.
The rectified DC power is converted back to AC by groups of devices called "inverters", which are also within the main control cabinet. Each inverter consists of six phase modules under the control of a gate driver power converter (GDPC). The two GDPCs control the operation of each phase module. Power Steering Each phase module contains paired positive and negative semiconductor switches referred to as insulated gate bipolar transistors (IGBT). The IGBTs cycle on and off at varying frequencies to create an AC power signal from the DC supply. The truck is equipped with a full time power steering system which provides positive steering control with minimum operator effort.
The system includes nitrogen-charged accumulators which automatically provide emergency power if the steering hydraulic pressure is reduced below an established minimum. The AC power signal produced by each inverter is a variable-voltage, variable-frequency (VVVF) signal. Frequency and voltage are changed to suit the operating conditions. Dynamic Retarding Cooling air for the control/power group and wheel motors, as well as the alternator itself, is provided by a main blower mounted below the control cabinet. The dynamic retarding is used to slow the truck during normal operation or control speed coming down a grade.
The dynamic retarding ability of the electric system is controlled by the operator through the activation of the retarder pedal in the operators cab and by setting the RSC (Retarder Speed Control). Dynamic retarding is automatically activated, if the truck speed goes to a preset overspeed setting. AC Induction Traction Motorized Wheels The alternator output supplies electrical energy to the two wheel motors attached to the rear axle housing. The motorized wheels use three-phase AC induction motors with full-wave AC power. Brake System The two wheel motors convert electrical energy back to mechanical energy through built-in gear trains within the wheel motor assembly.
The direction of the wheel motors is controlled by a directional control lever located on the center console. Service brakes at each wheel are oil-cooled multiple disc brakes applied by an all-hydraulic actuation system. Depressing the brake pedal actuates both front and rear brakes after first applying the retarder. All wheel brakes will be applied automatically if the brake system pressure decreases below a preset minimum. Suspension The parking brake is a wet disc type, integral to the service brakes, and is spring-applied and hydraulically- released with wheel speed application protection (will not apply with truck moving).
Hydrair II ® suspension cylinders located at each wheel provide a smooth and comfortable ride for the operator and dampens shock loads to the chassis during loading and operation.