Komatsu — Speedometer/Load Display

Payload Meter III - Section 60 2/11 OM6012 Page 60-2 COMPONENT DESCRIPTION System Diagram Suspension Pressure Sensors Speedometer/Load Display PLMIII uses a two-wire pressure sensor. The range for the pressure sensor is 281 kg/cm 2 (4000 psi) and The speedometer/load display is used as a speedometer and as a payload information display. The top display is used for speed and can display metric (km/h) or English (mph) units. See “Digital Display Operation” in Section 32 for instructions on setting the displayed units. The speedometer can be adjusted using a calibration potentiometer in the back just like existing speedometers. the overload limit is 700 kg/cm 2 (10,000 psi).

One wire to the sensor is the supply voltage and the other is the signal. The 0 - 281 kg/cm 2 (0 - 4000 psi) range is converted into an electrical current between 4 and 20 ma. The supply voltage for the sensor is nominally +18VDC. Each pressure sensor has an 3000 mm (118 in.) length of cable. The cable is specially shielded and reinforced to provide mechanical strength and electronic noise immunity. The payload meter uses the lower display for payload information. The normal display mode shows the current payload. The display can be changed to show the load and total tons counter or the Operator ID.

Using the operator switches on the dash panel, the current suspension pressures and incline can be displayed. The units for display are set using the PC software. Payloads can be displayed in short tons, long tons or metric tons. Inclinometer The inclinometer is used to increase the accuracy of load calculations on an incline. The inclinometer uses three wires. For the sensor, red is the +18VDC supply voltage, black is ground and the white is the signal. The incline signal is a voltage between 1 and 4 volts. Zero degrees of incline is represented by 2.6VDC on the signal line. The voltage signal will be decreased by 0.103VDC for every degree of nose up incline.