Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT

. MAINTENANCE SERVICE PROCEDURE CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT WARNING After cleaning, press the reset button to reset the piston. NOTICE Always wait for the yellow piston in the dust indicator to overlap the red zone on the outside before cleaning the element. CLEANING OR REPLACING OUTER ELEMENT NOTICE Before and after cleaning the element, do not leave or keep it in direct sunlight. it out. NOTICE inner element. It will allow dirt to enter and cause 4 - 26 Always wear pro tective glasses, dust mask, o r other protective equipment.

When removing t he air cleaner element from t he air cleaner bo dy, it is dangerous to pull it out by f When working at high places or where the foo thold is poor, be careful not t o fall because of the rea ction when pulling out the outer element. CHECKING If the internal yell ow piston overlaps the red zone on the outside If outside diameter of dust i ndicator (1), clean the air cleaner elemen If the element is cle indicator overlaps aned frequently before the the red zone on the outside yellow piston in the dust , the air cleaner will be unable to display i become poor.

ts normal performance and the cleaning effect will In addition, the freq uency of dust stuck to the e lement falling in side the inner element durin g the cleaning operation will increase. 1. Remove 6 ho oks (2), then remove cove Remove oute 2. Hold the oute r element, rock it lightly u p and down an d to the left and right, and rotate the element to t he left and righ t to pull failure of the eng Do not use a scr 3. After removin g the outer element, co ver the air co nnector inside the air dirt or dust fro cleaner body with a clean cloth or tape to prevent m entering.