Komatsu — CHECK AND ADJUST AIR CONDITIONER

. MAINTENANCE SERVICE PROCEDURE CHECK AND ADJUST AIR CONDITIONER CHECK LEVEL OF REFRIGERANT(GAS) WARNING 4 - 39 CHECK TENSION OF COMPRESSOR BELT If t he belt is loose, it will slip and the co oling effect will b e reduced. From time to time , press a point midw ay between the d rive pulley and compressor p ulley with your finger (approx. 58.8 N { 6 kg}) and check that the ten sion is 15 to 18 mm When the belt is adjust again after When handling refrigerant gas, always follow local laws and regulations.

The refrigerant u sed in the cooler is co lorless and odorles s and does not harm the atm osphere, but if the liqui d gets into your eye s or on your hands, it may cau se loss of sight or fros tbite, so never loos en any part of the refrigerant circuit. If t he level of the r efrigerant (gas) is lo w, the cooling eff ect will be reduced. Run the engine at high idle refrigerant in the refrigerant circuit thr receiver when the cooler is running at No bubbles in r efrigerant flow: Suita Some bubbles (bubbles pass continuously): Lack Colorless, trans parent:

No refrigera REMARK When there ar e bubbles, the refrigerant gas level is low, so contact your re frigerant dealer to h ave refrigerant ad ded. If the air conditioner is run with the refri gerant gas level low, it will efrigerant. cause damage New Freon R1 to the compressor. 34a is used as the r Charge amount o f air conditioner refri gerant (gas): 110