. MAINTENANCE SERVICE PROCEDURE WARNING the filter the will be the filter packing, so and down, 4 - 57 REPLACE FUEL FILTER Prepare a filter wrench a nd a container to catch the fuel. Engine is at high tempera ture immediately after the machine has been operated. Wait for engine to co ol down before replacing the filter. Do not bring fire or spark When bleeding the air, be careful not to let the fuel overflow. It may cause a NOTICE Genuine Komatsu fuel fil ter cartridges use a special filter th at has highly e fficient filtering ability. When replacing the filter cartridge, always use a g enuine Komatsu part.
The common rail fuel inj ection system used on this machin e consists of m ore precise parts than th e conventional injection pump and nozzle. If any part other than a ge nuine Komatsu filter cartridge is us ed, dust or dirt may get in and cause pr oblems with the injection system. Always avoid us ing substitute parts. When carrying out inspe ction or maintenance of the fuel sys tem, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fue l to wash it off completely. 1. Set the container und oil. er the filter cartridge to catch th 2. 3. Close valve (1) of fue Using a filter wrench, l strainer part. turn filter cartridge (2) counterc to remove it. 4.
Clean the filter holde coat the packing su holder. When installing tight r, fill a new filter cartridge with c rface with oil, then install it to en until the packing surface con 5. seal surface of the fil ter holder, then tighten 3/4 to 1 If the filter cartridge is tightened too far, the packin will lead to leakage of fuel. If damaged and this cartridge is too loose , fuel will also leak from the pa correct amount. always tighten to the 6. Open valve (1) of fue l strainer and loosen air bleeding 7. Loosen the knob of primimg pump (4), move it up a and continue until no more bubbles come out with the air bleed plug (3). 8.
Tighten air bleed plug (3), push in the knob of priming then tighten it.