Komatsu — CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING 5 kgm, 47.0 ± 10.8 lbft) 4 - 56 EVERY 500 HOURS SERVI Maintenance for every 250 hours should be performed at the sam The oil is at high temperature after the engine has been operated, so never change the oil immediately after finishing operations. Wait for the oil to cool down before ch anging it. Use a venturi component type Prepare a socket wrench and f Refill capacity: 121 liters (31.97 1. Open cover under the chass under drain valve (2). Remove drain plug (1) and s drain the oil. is. Set a container to catch oil lowly open drain valve (2), and 2.

Take care not to open drain va lve (2) so much that the stopper pin in the valve is distorted. ug (1): 68.6 ± 9.81 Nm Tightening torque for drain pl (7 ± 1 kgm, 50.6 ± 7.2 lbft) Tightening torque for drain va lve (2): 63.7 ± 14.7 Nm (6.5 ± 1. 3. Check the drained oil, if there is excessive metal particles or foreign material, contact yo ur Komatsu distributor. 4. Close drain valve (2) and inse rt and tighten drain plug (1). e each filter cartridge (3) in turn, achine. ew filter cartridge with engine oil, thread with engine oil (or coat it l the filter cartridge.

idge, bring the packing surface er, then tighten a further 3/4 to 1 idge, add engine oil through oil s between the H and L marks on short time, then stop the engine, etween the H and L marks on the CK OIL LEVEL IN ENGINE OIL . een operated for 500 hours, the replaced when the machine has machine has not been operated lter cartridge must be replaced perated for 500 hours. 5. Use a filter wrench and remov e each filter cartridge (3) in turn, starting from the front of the m achine. 6. Clean the filter holder, fill the n ew filter cartridge with engine oil, 7.

coat the packing surface and thread with engine oil (or coat it thinly with grease), then instal When installing the filter cartr l the filter cartridge. idge, bring the packing surface into contact with the filter hold er, then tighten a further 3/4 to 1 turn. After replacing the filter cartr idge, add engine oil through oil 8. filler port (F) until the oil level i s between the H and L marks on the dipstick. 9. Run the engine at idling for a short time, then stop the engine, and check that the oil level is b etween the H and L marks on the dipstick. For details, see "CHE PAN, ADD OIL (PAGE 3-91)" CK OIL LEVEL IN ENGINE OIL .

Even if the machine has not b een operated for 500 hours, the oil and filter cartridge must be replaced when the machine has been operated for 12 months. machine has not been operated In the same way, even if the for 12 months, the oil and fi lter cartridge must be replaced when the machine has been o