Komatsu — EFFECTIVE USE OF MODE SELECTION SYSTEM

. ATTACHMENTS, OPTIONS SHOE SLIP CONTROL RIPPING OPERATIONS 6 - 17 SHOE SLIP CONTROL This makes it possible to reduce the frequency of operation of the decelerator pedal by the operato r, and contributes to reduction in operatorfatigue. It also prevents wasteful shoe slippage, improves the ercarriage, and reduces fuel d: F1 g e operator uses the decelerator Applicable operations: Rippin In normal ripping operations, th pedal to control the engine spee d while carrying out ripping. If the shoe slip control is turned ON, th e shoe slip control system aids the operator in carrying out this cont When the shoe slip control switc rol.

h is turned ON, the rock selection mode is automatically set to [3]. Carry out operationsin this condition, and if the shoe slip ratio is too high, press a switch in the hard direction to set the mode to [4] or [5]. If the shoe slip ratio is low and there seems to be lack of power, press the switch in the soft direction to set the mode to [2] or [1]. REMARK After the joystick is set to F1, the shoe slip control starts when the ripper lever is operated to LOWER or TILT. Even when the operation alternates between need to turn the switch ON o dozing and ripping, there is no r OFF. slippage occurs during ripping With this system, if shoe operations, the engine spee shoe slippage.

If shoe slippage occurs du d is lowered to prevent wasteful ring ripping operations and the engine speed goes down, if th e ripper lever is operated to TILT IN or RAISE, the engine spee d will rise (output is increased) to make it easier to carry out br eaking operations. When carrying out ripping ope rations on hard rock, if the rear of the machine comes off the g round and there is sudden shoe slippage, it is possible to redu ce the shoe slippage by operating the ripper to LOWER and red ucing the engine speed.