. SAFETY PRECAUTIONS FOR OPERATION of the the If 2 - 21 TRAVELING ON SLOPES ng to the side, always do as follows. mately 20 to 30 rgency, quickly e to stop. Apply essary. ling at an angle To prevent the machine from tipping over or slippi When traveling on slops, keep the blade approx c l t m (8 to 12 in) above the ground. In case of eme ower the blade to the ground to help the machin he brake and use the engine as a brake, if nec Always travel straight up or down a slope. Trave or across the slope is extremely dangerous. Do not turn on slopes or travel across slopes. Always go down to a flat place to change the position machine, then travel on to the slope again.
T ravel on grass, fallen leaves, or wet steel plate s with low speed. Even with slight slopes there is a hazar t he machine may slip. When driving down a slope, never shift gear or place the transmission in neutral. The engine brake cann u u sed and this creates a dangerous condition. Al ways travel downhill in the same speed range as when tra phill. When operating on slopes of a grade of more than 15°, use F1 or R1. avel speed. When turning on a downhill ground, lower the tr PROHIBITED OPERATIONS T o make it easier to escape if there is any proble m, set the tracks at right angles to the road shoulder or clif t he sprocket at the rear when carrying out oper ations.
When operating the machine, take care that it wi ll not exceed its performance values such as stability, max u sing load, etc. to prevent rolling of the machine caused by an overload and disasters caused by breakage work equipment. USING BRAKES When the machine is traveling, do not rest your f oot on the brake pedal. If you travel with your foot resting o p edal, the brake will always be applied, and this will cause the brakes to overheat and fail. Do not depress the brake pedal repeatedly if not necessary. If this is neglected, the brake will be overheate will not work when required. of the engine.
When traveling downhill, use the braking force OPERATE CAREFULLY ON SNOW S now-covered or frozen surfaces are slippery, s o be extremely careful when traveling or operating the mac a c nd do not operate the levers suddenly. Even areful when working on slopes. With frozen ground surfaces, the ground beco a slight slope may cause the machine to slip, so be partic mes soft when the temperature rises, and this may caus machine to escape. machine to tip over or make it impossible for the I f the machine enters deep snow, there is a haz ard that it may tip over or become buried in the snow. Be c n ot to leave the road shoulder or to get trapped in a snow drift.
When clearing snow, the road shoulder and obje cts placed beside the road are buried in the snow and cann s c een. There is a hazard of the machine tipping arefully. over or hitting covered objects, so always carry out oper When traveling on snow-covered slopes, never a pply the brakes suddenly. Reduce the speed and use the e a n s a brake while appling the foot brake inte rmittently (depress the brake intermittently several time p the machine. ecessary, lower the blade to the ground to sto