Service Manual for WD10 Diesel Engine (2) All kinds of protective caps only need to be removed before assembling; (3) Place the injector into cylinder cover and tighten injector clamping bolt to 3Nm; (4) Loose injector clamping bolt until axial force posed on injector is 0kN; (5) Pre-tighten high pressure joint to 15~20Nm (nuts); (6) Tighten injector clamping bolt for 10Nm+120°; (7) Tighten high pressure joint to 50~55Nm (nuts); (8) High pressure joint, O-shape seal rings and sealing gaskets are disposal and cannot be reused, check the O-shape seal rings and sealing gaskets for sealing performance after assembling. 98