Service Manual for WD10 Diesel Engine c) High charging voltage d) Unstable charging voltage 128 Fault 3: High charging voltage Phenomenon Fault detection Troubleshooting High charging voltage reading on voltmeter a. Check whether voltmeter is damaged. b. Check whether wires, connectors and bolts in charging system are loose and producing too much heat, check whether there is short circuit in circuits and generator housing. c. Check whether the battery can work normally. d. Measure output voltage of generator W/R/AC terminal (should be about half of B+ terminal voltage). e. The fault is still existed after finishing above inspections. a.
Measure generator B+ terminal voltage, which should be within 27.8~28.4V, if the voltage is normal, then it means voltmeter failure and should be repaired or replaced. b. Retighten the bad-contact parts and loose wires, re-plug the loose connectors firmly. If there is short circuit, reconnect the wires. c. Check whether the charging current drops quickly in short time (from 50A to 10A or lower); consider a battery replacement if not. Check whether battery is clean and dry, whether its terminals and clamps are in good condition, replace them if damaged. d.
If there is big difference between terminal W/R/AC output voltage and normal range and big voltage drop happened after the engine loaded, then it means failure in generator rectifier bridge or stator, consider to repair or replace. e. Replace generator regulator, stator or the whole generator. Fault 4: Unstable charging voltage Phenomenon Fault detection Troubleshooting When the engine is running normally, voltmeter indicates charging, but the pointer is always oscillating and cannot be read (or charging indicator twinkling) a. Generator belt and relevant pulley belts are loose. b. Bad contact in charging circuit. c.
Collecting ring accumulates too much dirt, or electric brush is severely worn, or brush spring is weak or broken. d. Damaged regulator. a. Tighten generator belt and relevant pulley belts. b. Check and fasten all connectors in charging circuit. c. Clean the dirt, or replace the brush and brush spring. d. Replace the regulator.