Service Manual for WD10 Diesel Engine deformed fins with nipper plier carefully. 14) Adjust the belt tension periodically. A freshly installed belt should be adjust to required tension, adjust the belt tension again after 30min run-in period. 15) Pay attention to anti-loose and cleanliness of electric connectors. 16) Check whether there is oil dirt on A/C cooling system connecting parts, check each hose for wear, aging, crack and oil leakage. 17) Long-time no using A/C may result in oil film dry out of some compressor parts, which may affect performance or service life of A/C.
So please remember to operate the compressor at least once every month for 1~2min to keep the oil film in good condition. 18) Required refrigerant for A/C system is HFC-134a, periodically check refrigerant level because of insufficient refrigerant will reduce cooling performance, even result in compressor failure. 19) After installing a new compressor, firstly you should test-run the A/C system at idle speed and 1500~1750rpm. It is strictly prohibited to speed up the engine to 2000rpm to test the A/C, otherwise the compressor may be damaged instantly. 20) Refill lubricating oil if some parts of A/C system are replaced. Refer to Table 4-5.
Table 4-5 Lubricating oil refill (4) Leakage detecting methods for car A/C system Leakage detecting methods for car A/C system mainly including: visual inspection method, soap-suds inspection method, dye inspection method, electronic device inspection method, positive pressure inspection method and negative pressure inspection method. 134 Part name Lubricating oil refill quantity (ml) Compressor After removing the compressor, all residual oil in the compressor must be drained to a measuring cup, and the drained oil cannot be reused.
Required lubricating oil quantity for the new compressor is the residual oil quantity plus extra 30~50ml; If the removed compressor needs to be installed on a new A/C system, then the lubricating oil in the compressor doesn’t need to be drained, install it directly. Evaporator 30 Receiver drier 10~30 Condenser 30 Hose 10~30 System air leakage 60