Weichai — Weichai WD10 Diesel Engine Service Manual

Service Manual for WD10 Diesel Engine 4254 Steps to Assemble Hanger Plates Firstly distinguish the front hanger plate and rear hanger plate, front hanger plate should be installed on front end of engine (fan end), and rear hanger plate should be installed on rear end of engine (flywheel end), fasten the plates with M12 hexagon bolts (as shown in Fig. 4-6), required tightening torque is 100~125Nm. 426 Disassembly, Inspection, Maintenance and Assembly of Cylinder Cover 4261 Exploded View of Cylinder Cover Cylinder cover main bolt Nut Clamp block Clamp block Cylinder cover Cylinder cover gasket Cylinder cover auxiliary bolt Cylinder block Fig.

4-7 Exploded view of cylinder cover 4262 Steps to Disassemble Cylinder Cover Before removing the cylinder cover, it is required to remove the parts that are installed on cylinder cover first, including: intake pipe and exhaust pipe (refer to 46 Intake and Exhaust System for details), fuel pipes and wiring harnesses (refer to 47 Fuel system for details), cylinder cover shield, oil-gas separator, water outlet pipe and hanger plates (refer to 42 Cylinder Cover Assembly for 43