Service Manual for WD10 Diesel Engine abrasion. (2) Measure camshaft main journal circular run-out. (3) Measure tappet maximum lift (distance between cam tip and base circle) (4) Check timing gear for interference and severe tooth face wear. 4524 Steps to Assemble Camshaft After disassembling, examine camshaft and timing gear, and parts with wear or large parameter deviation should be repaired or replaced. (1) Rub-up camshaft fitting hole with towel and check the hole for bump damage, apply proper amount of lubricating oil on camshaft sleeve inner surface. For camshaft fitting hole that involving bump damaged should not be reused even after repair.
(2) Place camshaft guide tool and lubricating sleeve into the fitting hole, rub-up camshaft and check for bump damage, and then insert camshaft into camshaft fitting hole, remove camshaft guide tool and lubricating sleeve after the camshaft is properly fitted. Be careful not to crash camshaft sleeve during the inserting process. (3) Install camshaft thrust plates, loose-fit the pre-glued hexagon bolts and tighten them. Tightening torque of the bolts should be 29~35Nm. (4) Apply KB277 sealant on camshaft fitting hole bowl shape plug fore-end, the sealant trace should be continuous and enclosed.
And then press the plug into camshaft fitting hole and clean up the remnant sealant around the plug, make sure the plug is free of turnup. 78 Camshaft Maximum allowed circular run-out Measured value The second main journal (Between cylinder 1 and cylinder 2) 0.04 The third main journal (Between cylinder 2 and cylinder 3) 0.05 The fourth main journal (Between cylinder 3 and cylinder 4) 0.06 The fifth main journal (Between cylinder 4 and cylinder 5) 0.05 The sixth main journal (Between cylinder 5 and cylinder 6) 0.04 Camshaft Standard value Measured value Intake tappet maximum lift 7.0743mm Exhaust tappet maximum lift 8.3183mm