Service Manual for WD10 Diesel Engine (5) Turn the engine anticlockwise (view from timing gear housing end) until cylinder 1 and 6 reach TDC. At this point, piston upper end should be aligned to cylinder block upper surface. (6) Draw a straight line across flywheel housing and flywheel, install the dial and adjust it until 0° position is aligned to the “half line” on flywheel housing, install timing gear. (7) The mark on timing gear should be aligned to “OT” mark on timing gear housing. (8) Screw on the pre-coated hexagon bolts and tighten them diagonally, required tightening torque is 32~36Nm.
Leave a white mark on one of the bolts after tightening, measure and record the side clearance between timing gear and intermediate gear according to requirements. (9) Required side clearance between timing gear and intermediate gear is 0.015~0.33mm. Install the cylindrical pins. 453 Disassembly, Inspection, Maintenance and Assembly of Rocker and Rocker Shaft 4531 Exploded View of Rocker and Rocker Shaft Hexagon bolt Adjusting nut Supporting arm Adjusting bolt assembly Intake rocker Exhaust rocker assembly assembly Rocker shaft Fig. 4-43 Exploded view of rocker and rocker shaft 79