Service Manual for WD10 Diesel Engine valve clearance: As shown in Fig. 4-44, firstly loose the adjusting bolt 2, and then adjust valve clearance adjusting screw on pushrod end 10 without compressing exhaust valve rocker sealing surface until total valve clearance is 0.4mm, and then tighten adjusting nut. ( ATTENTION: In the adjusting process, you should rotate the valve clearance adjusting screw until the feeler gauge is gently infibulated, so that valve rocker piston 5 can be pushed to the bottom and no clearance between piston and piston hole bottom ).
11 Hexagon bolt 12 Supporting arm 1 Adjusting nut 2 Bolt 3 Valve-rocker assembly 4 Steel ball 10 Pushrod end 5 Valve-rocker piston 6 Piston spring 9 Rocker seat 7 Roller pin 8 Ball valve spring Fig. 4-44 As shown in Fig. 4-45, place a 0.25mm feeler gauge between rocker piston and exhaust valve, and adjust valve clearance to 0.25mm by adjusting bolt assembly 2, tighten the locknut. ATTENTION : In the adjusting process, you should rotate bolt assembly 2 until the feeler gauge is gently infibulated, so that valve rocker piston 5 can be pushed to the bottom and no clearance between piston and piston hole bottom Fig. 4-45 Fig. 4-46 81