Weichai — Weichai WD10 Diesel Engine Service Manual

Service Manual for WD10 Diesel Engine 456 Disassembly, Inspection, Maintenance and Assembly of Intermediate Gear 4561 Exploded View of Intermediate Gear Sleeve Intermediate gear shaft Fig. 4-49 Exploded view of intermediate gear 4562 Steps to Disassemble Intermediate Gear (1) Remove air compressor, refer to disassembly of engine accessory system for details; (2) Remove fuel injection pump, refer to disassembly of fuel system for details; (3) Remove camshaft timing gear, refer to disassembly of valve mechanism for details; (4) Remove the four M10 fastening hexagon bolts of intermediate gear, take down the gaskets.

Screw a M8 bolt into the gear shaft end hole to pull the shaft out, pay attention to avoid intermediate gear falling off; (5) Take down intermediate gear assembly and intermediate gear shaft along with the gear housing, and then take them out from the opening of gear housing. 4563 Inspection and Maintenance of Intermediate Gear (1) Check whether the bolts are in good condition; (2) Check each gear for peeling off and tooth breakage failure, check each bolt bearing surface for crush, and check whether the threaded hole or through-hole on gear is deformed. (3) Check whether there is abnormal wear between intermediate gear shaft and intermediate gear sleeve.

Check and make sure each oil hole is free of dirt and unblocked. 85 Gasket Bolt Intermediate gear