Service Manual for WD10 Diesel Engine 4552 Steps to Disassemble Valve (1) Depress valve springs with vale spring compressor or valve overhead plier or other tools, take out valve lock clamp, upper valve spring seat and lower valve spring seat and valve springs orderly; (2) Take valve out of valve seat. 4553 Inspection and Maintenance of Valve (1) Check whether valve rod and its end faces are worn; (2) Check whether valve conical surface is worn or damaged; (3) Check valve conical surface for carbon deposit; (4) Check valve retainer end faces for carbon deposit and sintering. 4554 Steps to Assemble Valve A valve with severe wear or carbon deposit or sintering should be replaced.
(1) Apply molybdenum disulfide cream on intake and exhaust valve rods, and then install intake and exhaust valves into cylinder cover, ensure the valve can slide smoothly in valve guide pipe; (2) Apply thread locking sealant on exhaust valve lower spring seat and then install it on cylinder cover, check whether the seat is properly fitted, repair or replace if necessary. Do not fiercely knock the seat to position. (3) Assemble lower valve spring seat of intake valve, install valve rod protecting cover into valve guide pipe, and then install valve rod seal cartridge; ATTENTION: Check and ensure spring in valve rod seal cartridge is in good condition before assembling.
(4) Install valve inner and outer springs; (5) Assemble upper valve spring seat, depress the springs and install valve lock clamp; (6) Knock the valve with rubber hammer to settle the lock clamp, if the valve lock clamp or upper valve spring seat cannot be settled, please find out the cause and eliminate it. 84