Service Manual for WD10 Diesel Engine 462 Disassembly, Inspection, Maintenance and Assembly of Intake Pipe 4621 Exploded View of Intake Pipe Stud Nut Intake pipe end cover gasket Intake pipe end cover Intake pipe bolt Intake pipe adapter Fig. 4-51 Exploded view of intake pipe 4622 Steps to Disassemble Intake Pipe (1) Screw off intake pipe bolts orderly, take down the pipe and gaskets; (2) Screw off intake pipe adapter fastening nuts, take down the adapter, intake heater and heater gaskets; (3) Screw off intake pipe end cover fastening nuts, take down intake pipe end cover and gaskets orderly.
4623 Inspection and Maintenance of Intake Pipe (1) Check intake pipe for crack and distortion, replace the pipe if necessary. (2) Check intake pipe gaskets and end cover gaskets for deformation and dilaceration, replace it if necessary. (3) Check intake heater for burnout and short circuit, replace it if necessary. 4624 Steps to Assemble Intake Pipe Assembling steps are contrary to disassembling ones. Recommended tightening torque for intake pipe bolts is 23Nm. 88 Intake pipe gasket Intake pipe Intake heater Intake heater gasket Stud Nut