Weichai — Weichai WD10 Diesel Engine Service Manual

Service Manual for WD10 Diesel Engine 463 Disassembly, Inspection, Maintenance and Assembly of Exhaust Pipe 4631 Exploded View of Intake Pipe Front exhaust pipe Exhaust pipe seal ring Exhaust pipe gasket Exhaust pipe bolt Rear exhaust pipe Exhaust pipe heat shield bolt Heat shield bolt Heat shield bolt Exhaust pipe heat shield bolt Fig. 4-52 Exploded view of exhaust pipe 4632 Steps to Disassemble Exhaust Pipe (1) Screw off exhaust pipe heat shield bolts orderly and take down the shield; (2) Remove exhaust pipe fastening bolts, take down front and rear exhaust pipes and gaskets. (3) Separate front and rear exhaust pipes, remove front exhaust pipe adapter and seal rings.

4633 Inspection and Maintenance of Exhaust Pipe (1) Check whether there is crack on exhaust pipe, whether the flange is deformed, replace the pipe if necessary. (2) Check whether there is air leakage on exhaust pipe flange, replace the gasket if necessary. (3) Check exhaust pipe gasket for deformation and dilaceration, replace it if necessary. (4) Check exhaust pipe seal rings for sintering, rust and carbon deposit, replace it if necessary. 4634 Steps to Assemble Exhaust Pipe Assembling steps are contrary to disassembling ones. Note the following points during assembly:

(1) Pay attention not to scratch exhaust pipe adapter when assembling the seal rings, the openings of four seal rings should staggered for 90°. 89