. MAINTENANCE SERVICE PROCEDURE suction side of the 2. Supply air to the pressurizing air hose to pressurize the hydraulic tank. NOTICE To prevent the oil from spurting out, pressurize the hydraulic tank gradually. 3. When oil flows from the plug hole and the air has been REMARK If all 4 plugs are loosened at the same time, oil will spurt out, so bleed the air from 1 plug at a time. 4 - 37 BLEEDING AIR FROM HYDRAULIC TAN K ter element, or strainer, bleed the air from inside the circuit.
After changing, replaci ng or cleaning the oil, fil ter elemen t, or straine r, bleed the air from in If the oil or element in th e hydraulic tank has bee n replaced , or any hydraulic cylinder, piston pump, work equipment, o r piston pump piping h as been removed, do a s follows to bleed the a ir after completing the replacement operation When bleeding the air, bleed the air from the p iston pump first, then bleed the air from the For details, please con sult your Komatsu distributor.
BLEEDING AIR FROM PISTON PUMP NOTICE If the air is not bleed com pletely, the piston pump m ay be damag ed, so alway s carry out the air bleed Before bleeding the air from the piston pump, ch eck that th e hydraulic i s filled with oil up to th e top of the sight gauge. (I f the oil level is low, a dd oil.) The cap of the h ydraulic ta nk remains r bleeding of the piston pump finishes. Remove plug (1) at the top of the hydraulic tan k, then con nect the pressurizing air hose. 8 Plug thread size: PT1/ BLEEDING AIR FROM TU 1. Loosen plug (2) o sen one place at a time. completely remov procedure to bleed There is a plug in t the bleeding opera the air from the other lo cations.
he suction tube of each pump, so c arry out tion for all plugs (4 plac es).