Komatsu — BLEEDING AIR FROM HYDRAULIC TANK

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR INSIDE PISTON PUMP (3) installed to the piston to the pressurizing air hose to pressurize the NOTICE To prevent the oil from spurting out, pressurize the hydraulic tank gradually. REMARK 4 - 38 1. Loosen pl place at a 2. Supply ai hydraulic t pump. (Loosen one 3. When oil fl ows from t he plug hole and the air has been completely removed, tighten plug (3). Repeat the same procedure to bleed t he air from th e other locations. There is a plug in the suction tube of eac h pump , so carry out the bleeding operation fo r all plugs (4 places If all 4 plugs a re loosene d at t he sam e time, oil will s purt out, so bleed the air from 1 plug a 4.

Check the hydraulic oil level, and add oil if the o il level is 5. Remove t he pressurizing air hose from th e hydraulic tank and install plug