www.changlin.com.cn 13 mm NOTE: Do not drop drive gear key when removing pump. Remove the three mounting nuts. Remove the fuel pump. Installing the Fuel Pump Make sure the engine has cylinder number 1 at TDC. The keyway in the shaft of new and reconditioned pumps will be locked in a position corresponding to the keyway in the drive gear when cylinder number 1 is at TDC on the compression stroke. After verifying that Cylinder Number 1 if at TDC, install the pump. Make sure the key does not fall into the gear housing. Attach the pump by finger tightening the three mounting nuts. The pump must be free to move in the slots.
22 mm (CAV Stanadyne), 24 mm (Bosch) Attach the pump drive shaft nut and spring washer. The pump may rotate slightly due to gear helix and clearance. This is acceptable providing the pump is free to move on the flange slots and the crankshaft does not move. NOTE: Do not overtighten. This is not the final torque. Torque Value: 15 to 20 N • m [11 to 15 ft-lb] 115 / 167 pages